 |
| ||||||||||||||||||||||||||||
- Protective lattices and guards:
These are placed in beating direction in order to protect fellow workers standing next to the chiselling place against splashing chips.
Figure 13 - Chiselling in front of
the safety lattice
- Safety goggles and beating protection:
The eyes are protected by wearing safety glasses.
Figure 14 - Chiselling with protective
device
A protective device of soft plastic material can be put over the head of the chisel in order to protect the back of the hand against strokes of the hammer that perhaps mise the head of the chisel.
What additional tools and auxiliary means are required for
chipping?
________________________________________________________________________________
What general rule applies to the selection of the
hammer?
________________________________________________________________________________
What qualities must the supports
have?
________________________________________________________________________________________________________________________________________________________________
When must marking-out tables and surface plates not be used as
supports?
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
What is the task of protective guards and safety
goggles?
________________________________________________________________________________________________________________________________________________________________
 |
 |
